The trench cover plate mold is prefabricated, because most of the mold is made of polypropylene, which is not suitable for on-site pouring. If the production method is not correct, there will be many situations that are not conducive to the normal use and damage the interests of manufacturers. The use steps of the groove cover plate mold are carried out in the way of small prefabricated blocks, and the processing methods are all superior materials. Only in this way can the safety production of the cover plate mold be guaranteed, and when the production is carried out, the special person will be responsible for it, so that the produced mold can meet the requirements.
As the groove cover plate mold belongs to plastic products, we need to pay special attention to avoid damage during transportation. Our factory will be responsible for the subsequent transportation of the mold, because only in this way can we ensure that the mold can be smoothly delivered to the customer's hands. Our factory has always adhered to a professional way to deal with, including mold production and transportation, after which we will contact the freight station to send cars for mold transportation. Mold protection is required before loading, which is a safe practice. Our factory will wrap a layer of plastic film around the appearance of these cover plate molds that need to be transported, so that when they are transported later, the molds made of plastic materials will not rub with the carriage, causing the whole mold to be damaged or unable to be used normally. Therefore, in the process of transportation, we need to ensure that the protection of the molds is reasonable, and then we can In order to place the mold, we will place different models of trench cover mold, and then stack up the same specification of mold on it, and then start the transportation.